Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

X-Controller Topper

5 likes
41 opens
21 copies
0 comments
Benjamin Grisinger

Project by

Benjamin Grisinger

General Information

check out this handy topper I made to put on top of my x-controller to hold bits, wrench, and allan wrench

Like this project Open in Easel®
1

Quick instructions

I used a 1/8 in upcut bit to make this.

I used a bit oversized piece of plywood and trimmed it into position once I had done the carve.