Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

X-carve Clamp Rack (1 of 3)

225 likes
2470 opens
1132 copies
5 comments
Chip Clark

Project by

Chip Clark

General Information

This is my version of the clamp holder modified from the one from Jeff Williams published and one of three organizers I made for my tooling and accessories. 3/4" MDF glued up to 1.5". 1/4" round over on the router table to finish the top edges.

Like this project Open in Easel®
Robert Guillory
My inventables is mobile and foldable so i can move it out of the way when not in us. With your organizer i can put everything in the drawers and it stays with machine. Thanks Chip this make it real easy for me.
Robert Guillory
Phil Reynolds
where is 2 of 3 and 3 of 3?
Phil Reynolds
Hanan Pinkhasov
Does anyone know where i can find parts 2 and 3? thank you in advance!
Hanan Pinkhasov
Hurel Guillaume
Go to root page for part 2 & 3 https://www.inventables.com/users/chip-clark
Hurel Guillaume
Jud Niven
Great Project...Thanks for sharing!!
Jud Niven