Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

X-Carve Bit Storage (2of3)

68 likes
1023 opens
558 copies
2 comments
Chip Clark

Project by

Chip Clark

General Information

This is the second of my X-carve tool and accessory holders and is a modification of the one published by Julien Hoffmeyer. 3/4" MDF and I used a 1/4" round over bit in the router table to finish the top edge

Like this project Open in Easel®
Matt Slaga
These are fantastic, I've carved all three pieces. They fit perfectly in my dedicated X-Carve drawer. Thanks for sharing!
Matt Slaga
Keith Lake
Carved #1 trying to Carve #2. will not move on to confirm bit? an you suggest something I might be doing wrong?
Keith Lake