Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Wooden Hinge Made in Easel

29 likes
167 opens
99 copies
0 comments
Gord Rock

Project by

Gord Rock

General Information

After seeing a wooden hinge made with Vectric software I wondered if I could produce one with Easel. I’m quite pleased with it. It is made to fit on a 5/16" dowel. To make a smaller, more delicate version just change the dimensions until you get a fit on a smaller dowel or rod.

Like this project Open in Easel®