Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Wine Glass Inlay

83 likes
833 opens
170 copies
2 comments
Paul Hodges

Project by

Paul Hodges

General Information

Wine glass inlay used on a wine bottle holder. Made with walnut, hard white maple and paduk.

Like this project Open in Easel®
Patrick J. Noel
i love that there is zero information about this, what angle is needed on the bottom
Patrick J. Noel
Michael J. Buranich
I am not sure if I can help, and I am yet to make this. Going off of other designs similar to this, they use a 42 degree angle. My suggestion is to start with a scrap piece to figure out the Angle & Hole then proceed with the rest of the carve.
Michael J. Buranich