This website uses cookies

We use cookies to personalize content, interact with our analytics companies, advertising networks and cooperatives, and demographic companies, provide social media features, and to analyze our traffic. Our social media, advertising and analytics partners may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. Learn more.

Wasteboard engraving 5cm2

7 likes
225 opens
50 copies
0 comments
Christian Lie Eikefjord

Project by

Christian Lie Eikefjord

General Information

To engrave a 5cm grid onto your wasteboard.

Usefull for the ones that diy their own. Use the smallest bit that followed in the geting started. Or a V-bit

Depth is set at 1.5mm, i did run it with 0.5mm and i discovered some sagging on my board.

Like this project Easel logo Open in Easel®