Toothpaste Squeezer
Project by
John Kalbac
General Information
Simple wooden toothpaste squeezer. Approximate size is 3"x3" with a 2.5" opening to accommodate most tubes. The opening is .125", which seems to give a good squeeze ratio.
Super quick cut; roughly 10 minutes on a Shapeoko 3.
Open in Easel®
1
Carve 1
Outline and through-cut with a .125" bit. Adjust the model if you want to add tabs for a full cut-out.
Estimated time: 5 minutes
2
Carve 2
Optionally perform the detail cut with a v-bit. I used a 60* with good results.
Estimated time: 5 minutes
Log in to post a comment to the designer