Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Standard 3 Wheel MakerSlide Carriage

Bart Dring

Project by

Bart Dring

General Information

This is a project to show the basic items needed to make a standard 3 wheel MakerSlide carriage. It includes some MakerSlide for reference. You should determine if the piece chosen is right for you. You can edit your cart at any time after adding.

Like this project
Material Description Price
Aluminum Spacers - #12, 5M

Aluminum Spacers - #12, 5M

Inside Dia.: .219 (5.56mm), Length: 0.25 in, Outside Dia.: .375 (9.53mm)

$2.99

Button Head Cap Screw

Button Head Cap Screw

Length: 30mm, Pitch: 0.8mm, Quantity: 10, Thread Size: M5

Dual Bearing V-Wheel Kit

Dual Bearing V-Wheel Kit (×3)

Type: Wheels dont use 1, Qty: 1 dont use 1

Eccentric Spacer

Eccentric Spacer

Spacer Type: Standard, Qty: 1 don't use, Length: 0.25 in

Hex Nuts

Hex Nuts

Width: 8mm, Height: 4mm, Pitch: 0.8mm, Quantity: 10, Thread Width: M5

MakerSlide - Black Anodize - 5M Tapped

MakerSlide - Black Anodize - 5M Tapped

Length: 1000mm - 2012 - 2019

Standard Wheel Carriage Plate

Standard Wheel Carriage Plate

Type: Plate

$3.37

This project's Bill of Materials is not complete.

$6.36
from Inventables

File Description Unit Price

b30039.stp

CAD File (STEP)

$0

Download Zip

$0
from Inventables

1

Assemble the wheels

Press a bearing into one side to the wheel. Place the shim washer on the bearing and press the second bearing into the wheel. The bearing can be pressed in by hand by pushing against a firm flat surface. Make sure the bearings are going in straight. You can use a 5mm screw to make sure the washer stays centered. If the washer moves it is easy to re-center it later with a thin item like a paper clip.

2

Install the fixed wheels

The wheels are installed on 3 holes in the corners of the plate. 2 holes of about 5.1mm diameter are used for fixed wheels. The carriage plate is not symmetrical, so look for the side of the plate that has the 2 smaller holes in the corners.

3

Install adjustable wheel

Place a mark on the eccentric spacer on the surface nearest the center hole. This will give you a reference for adjusting later. Install the spacer with the marks facing the outside of the carriage. This will start with the wheels in their widest position. Install the wheel in the larger diameter hole on the other side of the carriage from the fix wheels.

When you put the completed carriage on the MakerSlide adjust the wheels so they just light contact the rail. Excessive tightening will damage the wheels and put a flat spot on them