Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Spiderman Coaster

The Guru

Project by

The Guru

General Information

Spiderman face carved from HDPE from Inventables.

Like this project
Material Description Price
Two-Color HDPE - White on Red

Two-Color HDPE - White on Red

Thickness: 1/4 in, Dimensions: 12 in × 12 in, Quantity: 1

$9.97

$9.97
from Inventables

File Description Unit Price

spiderman-face2.svg

Source SVG file

$0

spiderman-face4.cb

CamBam file for milling

$0

Download Zip

$0
from Inventables

1

Load HDPE into Shapeoko

2 minutes

Load HDPE into Shapeoko

2

Home Shapeoko

1 minute

Move Shapeoko into home position over corner of material

3

Load code

Load gcode into UGS or appropriate controller

4

Send!

Send the file to the machine.

Dan Pearl III
Bit type, speed and fed rate? I am very new at this and still learning. Thanks
Dan Pearl III
The Guru
Hi Dan - DOC = 0.05" Feedrate = 30ipm Plunge = 10ipm Stepover = 35% Tool Diameter = 0.0625 Stock Dremel w/SO2. Speed = 8-10. You can definitely go faster on an X-Carve. I used a 0 helix bit - works best with HDPE. Best of luck.
The Guru
Dan Pearl III
Could you send me a link showing the 0.0625 Stock Dremel w/SO2.
Dan Pearl III
The Guru
Dan - what do you mean a "link showing the 0.0625 Stock Dremel"?
The Guru
The Guru
Ah, I think I understand. 0.0625 is the width of the bit; stock SO2 is just that - an unmodified ShapeOko2 with the stock dremel. Any X-Carve should work - you will need to experiment with speeds and feeds though.
The Guru