Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

skull

8 likes
379 opens
93 copies
4 comments
Kenneth James

Project by

Kenneth James
Gautier, Mississippi

General Information

sugar skull

Like this project Open in Easel®
heather s stearns
Hello...exactly which bit did you use to carve this project and where can I purchase that bit? I don't see one on the Inventables website.
heather s stearns
mark s
wondering same.
mark s
Roger Franz
Guys that's a rendered picture, not a carving.
Roger Franz
Roger Franz
For 2.5D Carving you need 2 bits, a roughing bit, could be your 1/4 inch downcut but for the details you need a tappered ball nose bit like: SpeTool Tapered Ball Nose End Mill 1/4" X 3" with 0.5mm Tip Diameter(0.25mm Radius) Ball Nose 5.26Deg Router Bit
Roger Franz