Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Side Clamps

48 likes
663 opens
375 copies
2 comments
Neil bartlett

Project by

Neil bartlett

General Information

Side clamps that don’t require pressure from the top, leaving the whole work surface open for carving. Spans 2 holes in width, works great xcarve green clamp screws. Not tall enough for 2 holes front and back, may have to extend if projects aren’t fitting between a set.

Like this project Open in Easel®
Keith Fritze
I made a set of these about 6 months ago. I used a Bamboo cutting board from dollar tree to make them. Super hard and durable. These clamps have been indispensable! Nice job!
Keith Fritze
Jeff davis
Thanks... Adjusted the holes for 2 inch spacing. Nice clamp.
Jeff davis