Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

SawStop Insert

19 likes
108 opens
57 copies
2 comments
Gord Rock

Project by

Gord Rock

General Information

An insert for my SawStop Tablesaw. NOTE: I intentionally made this just a hair too long so that I could sand the ends for a very tight fit. The 4 small holes are for the addition of 1/4-20 insert nuts in case your Insert is not the exact thickness needed.

Like this project Open in Easel®
Paulo Munoz
Gord Rock what kind of bit did you use?
Paulo Munoz
Gord Rock
Hi Paulo, I used a 3/16" bit.
Gord Rock