Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Rolling Toy Truck

20 likes
169 opens
82 copies
6 comments
Mark Simon

Project by

Mark Simon
Batavia, OH

General Information

Rolling toy truck, made of 3/4" plywood and 1/2" dowel rod.

Like this project Open in Easel®
1

Toy Truck Assembly

Use 1/2" dowel rods for alignment during glue up. Apply clamps and remove dowels. Once dry, either sand dowels to slightly under 1/2" inch or bore out holes to slightly over. This will allow for dowels to rotate so the truck can roll around.

Corey Bourque
Made this truck turned out well
Corey Bourque
Brian Clancy
This is nice, i would like to try but when I download its only the truck walls. Is there anymore files for the tires, bed and everything else. ?? thanks
Brian Clancy
Brian Clancy
NVM I found them all on the bottom tab! Thanks
Brian Clancy
Mark Simon
glad i could help! hehe
Mark Simon
Glenn Haley
file unavailable would u care to share this one please
Glenn Haley
Mark Simon
sorry! i wiped this one recently.. i didn't realize this post would be affected. i'll remove this posting shortly..
Mark Simon