Rev 41 1476
Project by
Jon Anderson
General Information
A REV bracket at 30 degrees out of aluminum
http://www.revrobotics.com/rev-41-1476/
Project License
Attribution 3.0 Unported (CC BY 3.0)
Open in Easel®
Secure aluminum to fixture
Use the '12x12 Sheet Fixture':https://www.inventables.com/projects/12x12-sheet-fixture to secure the aluminum using rigid double sided tape or painter's tape and CA glue strategy.
Note: - REV uses 2mm (about 0.080") aluminum for these brackets. - YMMV depending on your application with 0.062" thick aluminum which is 80% as thick as the 2mm aluminum.
Estimated time: 5 minutes
Carve aluminum
Carve the aluminum using the Easel project.
Notes: - Use lubricant/cooling to extend the life of the bit - Use a brush or compressed air to remove the chips to improve finish and extend the life of the bit
Estimated time: 5 minutes
Release the part
Release the part using a knife, chisel, putty knife or similar. The whole sheet can be removed easily using the screwdriver/prybar release slot on the bottom of the fixture's cutting area.
Estimated time: 3 minutes
Debur
Debur the part as needed.
Estimated time: 5 minutes