Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Remake of "Work piece hold down clamps"

18 likes
140 opens
65 copies
0 comments
Matt Slaga

Project by

Matt Slaga
Jacksonville, USA

General Information

These are the same as Warren Downes project, just adjusted to fit a scrap piece of plywood (5in x 29in x .5in). These clamps hold firm, allowing the stock vac shoe to be all the way down on the project without having to worry about height. Also have pictures of the screws and washers used from L.

Like this project Open in Easel®