Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Remake of "Simple engraved bow tie"

3 likes
0 opens
0 copies
0 comments
Justin Robbins

Project by

Justin Robbins

General Information

A bit of a spin on the bow tie made here, but very similar. Found an SVG of my university and made a little bow tie!

Like this project Open in Easel®
Material Description Price
Walnut

Walnut

6" × 12" × 1/8" Walnut

$9.09

$9.09
from Inventables

1

Adapt Easel File

Found a picture that resembled the logo of the university I attended. I converted it to an SVG using Inkscape and replaced my design with the original file.

2

Cut!

I cut the design into a 1/4" piece of Walnut I had laying around the shop.

3

Remove Tabs and Sand

Removed tabs off of bow tie and sanded down the bow tie. Applied a mineral oil finish to seal the wood, and voila! Profit.