Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Remake of "Grow chart Share"

3 likes
58 opens
24 copies
2 comments
Makerneer Nate

Project by

Makerneer Nate

General Information

Great introduction to tiling project, thanks!
Carved on my XCP, red cedar, 90* V bit.
Painted one and went “rustic” on the other. Turned out great!

Like this project Open in Easel®
JP Fonder
Do you paint the entire thing and then sand it to get just the numbers and scale painted?
JP Fonder
Makerneer Nate
I used acrylic paint and a paint brush to get inside the cutouts, then sanded any mistakes. Went pretty quick. I think the cedar would need to be sealed if I was going to pain the whole thing and sand it back.
Makerneer Nate