Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Remake of "Easel Pro Design Challenge"

5 likes
77 opens
27 copies
252 downloads 1 comment
Jody

Project by

Jody
North Las Vegas, USA

General Information

Let’s see your design chops. Enter to win some amazing prizes like a brand new X-Carve!

Like this project Open in Easel®
Material Description Price
Baltic Birch Plywood

Baltic Birch Plywood (×2)

8" × 12" × 1/2" Baltic Birch Plywood

Carbide Tip Fishtail Upcut - 1/8 in Cutting x 1/8 in Shank

Carbide Tip Fishtail Upcut - 1/8 in Cutting x 1/8 in Shank

1/8" Upcut Fish Tail Carving Bit

$8.49

Carbide Tip V-Bit 60 Degree - 1/2 in Cutting x 1/4 in Shank

Carbide Tip V-Bit 60 Degree - 1/2 in Cutting x 1/4 in Shank

Shank Diameter: 1/4 in, Cutting Diameter: 1/2 in, Tip Angle: 60 Degree

$15.91

This project's Bill of Materials is not complete.

$24.40
from Inventables

File Description Unit Price

Dogbowl.zip

All zipped up

$0

Download Zip

$0
from Inventables

1

Assembly

This was simple assembly. I just used glue on all edges, the 3/4 inch brad nails to tack everything together. Sanding was minimal, just around the edges to soften them.

Bowl assembly, just used glue then clamp tight on four sides over night.

I used a Butcher Block oil on everything, to keep it food safe for the pups. Actually 3 solid coats and the bowls would hold water if needed. Don’t really recommend water, I have two dogs so both bowls just hold hard foods.

The two Aliens were just fillers from the cut out of the dog bowl holding spots. Plus gave me an extra chance to use some of the Easel Pro library clip art. Hate to waste wood, so I carved the aliens in both cut out circles. Good decoration for the shop, I live close to Area 51 so embrace your surroundings and let no wood go to waste.