Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Remake of "CNC Clamp and Tool storage"

1 like
26 opens
10 copies
4 comments
Tony Pittsley

Project by

Tony Pittsley
Orlando, USA

General Information

Cleaned up the alignment of the cutouts, and removed some storage to fit the space I had. When I make this again, I will enlarge the hold down holes, and remove the bit storage all together.

Like this project Open in Easel®
Prag Padilla
Would love to try this can you share the project?
Prag Padilla
Tony Pittsley
It should be shareable, I just opened the page and there is an "Open in Easel" tab. Let me know if that doesn't work, I'll try and post it again.
Tony Pittsley
scott irwin
This project has not been shared publicly
scott irwin
Mike Hamon
Still not shared publicly.
Mike Hamon