Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Plywood Nightstand

34 likes
255 opens
90 copies
0 comments
Yves Becker

Project by

Yves Becker

General Information

This is a little plywood nightstand, that takes just one hour to carve. It is done frome a sheet of 12mm thick cherry plywood.

Like this project Open in Easel®
1

Carve

58 minutes

First carve out all the parts of the nightstand with your X Carve.

2

Sanding

10 minutes

Sand all the edges.

3

Glue it together

60 minutes

Glue all the parts together as shown on the picture. Clamp everything together and let it dry.

4

Reinforce the joints with dowels

On the top and the side pieces, mark out the holes as shown in the pictures. Drill 6mm holes and glue in the wood dowels, so that they still stand out a bit. Saw them down with a japanese handsaw and sand them flush.

5

Apply a finish

You can apply all sorts of finishes, such as wax or oils.