Penny Engraving Jig

9 likes
108 opens
19 copies
3 comments
Josh Ajima

Project by

Josh Ajima

General Information

Engrave pennies with a super simple penny engraving jig.

Like this project Easel logo Open in Easel®
Christopher Elledge

Are you using anything to adhere the penny to the jig or dod you just place the penny in and start carving?

Christopher Elledge

Josh Ajima

The first two pennies had enough friction fit in the jig to carve cleanly. The third penny started to slip slightly at the end. I was using a scrap piece of pine so you may have better luck with a harder material or using an adhesive.

Josh Ajima

Zachary Chartrand

awesome project I was just wondering how deep was the engrave on the penny? and what kind of spindle where you using?

Zachary Chartrand