This website uses cookies

We use cookies to personalize content, interact with our analytics companies, advertising networks and cooperatives, and demographic companies, provide social media features, and to analyze our traffic. Our social media, advertising and analytics partners may combine it with other information that you’ve provided to them or that they’ve collected from your use of their services. Learn more.

New X Carve Modular Spoilboard

7 likes
0 opens
0 copies
0 comments
Scott O’Malley

Project by

Scott O’Malley

General Information

Modular design to use all holes and slots. I cut the blanks oversized then cut square after the holes were carved that wat it didn't need to be perfect on the table. I didn't carve all the way through to protect the factory board.

Project License

Attribution 3.0 Unported (CC BY 3.0)
Like this project Easel logo Open in Easel®
1

Blanks

Cut 4 Blanks of 1/2" MDF to roughly 240 mm x 770 mm. (9"x30")

Estimated time: 10 minutes

2

Carve Blank

Open file and set blank on table reasonable square. Secure and carve, I did each blank individually so figure 15 min x4.

Estimated time: 15 minutes

3

Drill out holes

Drill out holes to 100% depth, counter sink 4 corner holes and one center hole.

Estimated time: 10 minutes

4

Cut Square

Measure 30mm from the center of the holes running lengthwise, and 15mm from the center of the holes running widthwise and draw a rectangle. Cut the excess material off on the line to give you a final size of 220mm x 750mm.

Estimated time: 15 minutes

5

Surfacing

Anchor the spoil boards in place and surface to spec. Mark the location of each board because you will have to spin the boards and move the outer two to get the entire surface. Once surfacing is complete return the boards to their original locations.

Estimated time: 90 minutes