Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

new last supper.stl

19 likes
587 opens
325 copies
3 comments
shaun Erban

Project by

shaun Erban

General Information

Last Supper 3D

Like this project Open in Easel®
John Williamson
Thank you for sharing this project. It is my first 3D carve. Everything went well but my facial features didn't turn out on all the people. I am using 1/8 ball nose for finish and 1/8 down cut for rough. I set my depth to project the thickness of a piece paper. Any suggestions
John Williamson
shaun Erban
need to use a 2mm or smaller ball nose to get detail, and have less than 12% stepover.
shaun Erban
Nick McCartney
I've ran this cut twice now and both times in the same spot about 2/3rd from the top the shifts and throws the cut off. At first I thought the workpiece slid but after repeating the same cut and reenforced the hold downs and seeing the same mistake, I'm left scratching my head.
Nick McCartney