15 minutes
I designed this to fit my dial indicator mount, you may have to modify the size of the circles in order to fit your specific model.
The cutout is designed to minimize rotation of the dial indicator around the screw, and is composed of both a circle AND a square. Be sure to change the size of the square to match the diameter of the circle.
30 minutes
Choose the material you want to make this from and mount it on the X-Carve. I made my prototype out of 3/4" MDF, and the final product out of 3/4" maple.
10 minutes
Using a hand drill or drill press, drill the hole on the “right” side (side opposite notch) to 5/8" or 11/16", then screw in the M5 threaded insert.
If you plan on applying a spray finish, you may want to wait to screw in the threaded insert until after the finish is dry.
15 minutes
I prefer the raw material look, but sand loose fibers and sharp corners and finish as desired.
5 minutes
Using (1) M5x25mm bolt and washer, attach the dial indicator to the mount. Then use (2) M4x30mm bolts and washers to attach the mount to the spindle mount.
Moulton Designs