Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Modern Laptop Table with wireless charger

12 likes
27 opens
3 copies
0 comments
David Márquez Kacic

Project by

David Márquez Kacic
Santiago, Chile

General Information

I make a table for the notebook for bed and also be used to support her cell and charge it. The design is made with Soft Maple (750×250mm) and walnut for the holder. I make my own only for reference with some wood find in local store. Made with Pine 9mm and Chilean Raulí 10mm

Like this project Open in Easel®
Material Description Price
Soft Maple - Hardwood Type

Soft Maple - Hardwood Type (×5)

Dimensions: 6 in × 12 in - don't use, Thickness: 1/2 in - don't use

Walnut

Walnut

6" × 12" × 1/2" Walnut

1

Carve the back part

24 minutes

With the first workpiece, you must carve the part where the wireless charger will go and the cuts to bend the wood.

2

turn the wood and carve

You must turn the wood horizontally and place it in the same position as the previous stage.

3

Carve the cellphone holder

12 minutes

Now place the wood you want to use to make the cell holder, ideally it is a different wood than the previous one. And Carve

4

Sand

10 minutes

Now Sand

5

Bend the wood

20 minutes

Now you have to bend the wood, if you can’t, add hot water for a few minutes and it will become soft. Then place in the joints glue and hold it for a while so that it is stuck.

6

Sand again and barnish

20 minutes

Sand again and barnish