Make LED LIGHTS blink to music

6 likes
11 opens
2 copies
1 comment
michael jon barrett

Project by

michael jon barrett

General Information

LED Vu meter Make LED LIGHTS blink to music Under 5$ build! using the an6884 LED driver v - bit was used to carve the blank PCB search creative channel for a great tutorial here is the link https://www.youtube.com/watch?v=6gyhOeCgtmA

Like this project Easel logo Open in Easel®
1

carve paths

Secure circuit board blank onto X-Carve. Use a small v bit to carve the paths. Set z - axis to .014 inch set speed to 15 in/min CARVE! Takes 9 min to carve paths

Estimated time: 10 minutes

2

drill holes

change out the drill bit for a .03 inch bit. set cut speed to 30 in/min carve holes

Estimated time: 2 minutes

3

solder parts

carefully place and solder parts

Roger Shaddick

Could you post a parts list? Thanks

Roger Shaddick