lord of the rings
Project by
chris parks
Published On
April 16, 2018
General Information
simple engraving that i used for cutting boards, after engraving i paint the lettering and sand all extra paint off when dryed
Open in Easel®
I noticed in the simulated cut the "R" and the "D" seem to have been missed by the cut path. Will it in fact cut or is this a bad sample.
Don Yea · August 08, 2020
it shows that it cuts when i simulate from here so you should be good, try zooming in on the letters the cut path was small
chris parks · August 08, 2020
What font did you use?
Joseph Hernandez · December 09, 2022