Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

LOGO 1

0 likes
29 opens
2 copies
2 comments
Jeff Holmes

Project by

Jeff Holmes

General Information

This was my first try at cutting metal with the Xcarve.

Like this project Open in Easel®
Taylor Wade
Any information you could add to this? I'm assuming this was brass? What was your bit? Feed rate? Any other pointers when cutting this kind of material?
Taylor Wade
Jeff Holmes
I used an engraving bit and the default easel settings for aluminum. My lubrication was WD-40 that I would just spray on the brass every few minutes. I have found that a single flute bit works best with the Dewalt 611 router when cutting metal.
Jeff Holmes