Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Label Holder for Workshop Drawers

9 likes
32 opens
15 copies
0 comments
Paul J. Bennett

Project by

Paul J. Bennett
Milbridge, US

General Information

These label holders are made from 1/4"plywood and use the back of old business cards as labels.

Like this project Open in Easel®
1

Clamp plywood to X-Carve

Set up X-Carve with 1/4" plywood, and let ’er rip!

2

Remove Label Holders from plywood

Cut tabs and remove label holders. TRim off excess material and sand smooth

3

Prime and Paint, and Install

Finish as desired, and install label holders on drawer fronts.

4

Insert Labels

Use the backside of old business cards and write contents of drawers with a Sharpie or paint pen. Install labels in holders. You’re done!