Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Jesus_Cross_Layered

15 likes
275 opens
130 copies
3 comments
Shannon Dolese

Project by

Shannon Dolese
Lucedale, USA

General Information

Copy of Jesus_Cross layered with 3/4" Dark Walnut and 1/8" Hard Maple. Carved deep enough through the maple to allow the Walnut to show as the background. Also added outside with optional stand layout

Like this project Open in Easel®
tom
What size cnc machine did you use and how did you carve the top of the cross? Did you use a 3018 like your project very much
tom
Shannon Dolese
Xcarve 1000. Don’t understand the question about how the top was cut.
Shannon Dolese
Shannon Dolese
However, I glued a piece of 1/8" maple to 3/4" walnut for contrast and set the top cut to slightly deeper than the maple to clear to the walnut. Using purpleheart is also nice contrast.
Shannon Dolese