Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

FCCB Logo Camp Table.nc

12 likes
25 opens
9 copies
2 comments
HM Print & Design Wayne Hesler-Mondore

Project by

HM Print & Design Wayne Hesler-Mondore
Richfield Springs, USA

General Information

Table 2 of 10

Like this project Open in Easel®
Lyle Sutherland
very nice! i'm interested in setting up an xcarve to do similar work. do you mind if i ask what router and software you use?
Lyle Sutherland
HM Print & Design Wayne Hesler-Mondore
Dewalt 611 and vcarve pro for the paths. I use coreldraw x8 for desiging prior to exporting to vcarve and path creation. This was carved using a 90* .50" bit. Took about 45 minutes.
HM Print & Design Wayne Hesler-Mondore