Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

ESP-07s PCB Base

0 likes
12 opens
0 copies
0 comments
Ender Motion

Project by

Ender Motion

General Information

Base to use an ESP07s with a PCB.
Could work also for ESP-03/04/08/12 (not ESP-12E/12F), but I not guarantee.
Require 1mm bit, I suggest a 10mm hard material such as plastic or HDF/MDF (HDF is better).
To curve wire I suggest a 2mm drill bit or similar, this will allow you to do the job quickly.

Like this project Open in Easel®