Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Ear Savers

5 likes
35 opens
10 copies
2 comments
JOHN T LEHMAN

Project by

JOHN T LEHMAN

General Information

These prevent the chafing and makes it easier to wear the masks for extended periods of time. After these cut I put them on the belt sander at a 45* angle to soften the edge. This caused the chips to melt. But those chips pop right off after a few seconds of cooling down.

Like this project Open in Easel®
Heath A Grable
What did you cut these out of?
Heath A Grable
JOHN T LEHMAN
These were out of acrylic. They were a bit stiff. The next few batches were HDPE. Much better!
JOHN T LEHMAN