Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

DTC Table Saw Push Stick 1

4 likes
58 opens
27 copies
0 comments
Paul J. Bennett

Project by

Paul J. Bennett
Milbridge, US

General Information

Make your own table saw “push-stick” with FREE PLANS! Your fingers will thank you for it!

Like this project Open in Easel®
1

Cut Material to Size

5 minutes

Cut plywood to size (14″ × 8″).

2

Position Plywood on X-Carve and Carve"

Position the plywood on the X-Carve machine and let er’ rip!

3

Remove and Finish

Remove piece from X-Carve, cut the tabs to release the part, and finish with sand paper. Apply a couple of coats of Shellac. Your done!