Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

DIY Scrap Wood Trivet

72 likes
645 opens
250 copies
0 comments
Johnny Brooke

Project by

Johnny Brooke

General Information

I built a set of simple scrap wood wooden trivets using two methods: first, using “traditional” woodworking tools like my router table, and then using my Inventables X-Carve.

Like this project Open in Easel®
2

Create Trivet Blank & Run Easel File On One Side

I ran the Easel file on one side first, then flipped the trivet over and rotated it 90 degrees.

3

Run Easel File On Second Side Then Run Outline Operation

Run the Easel file again on the second side, then run the outline file : http://easel.inventables.com/projects/npTPeENu895Gl2an-lL23g

4

Roundover Edges, Sand & Finish

After the X-Carve is done, all that’s left to do is finishing. I rounded over my edges, did some sanding, and applied a few coats of polyurethane.