Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Clamp Set Rack

54 likes
378 opens
179 copies
1 comment
Jeff Williams

Project by

Jeff Williams

General Information

This is a storage block for the inventables clamp set for 3D carving. It was carved from a scrap piece of 2″ × 6″ × 12″ It also has a place for the Z probe and collet wrenches

Like this project Open in Easel®
Dan Caescu
I just tried to make this and failed big time on my first attempt. I used an 1/8 2 flute end mill. Everything was too small for all my clamping stuff. Did you use and 1/8” end mill bit? How long was it and do you know why if you used an 1/8” bit why mine would have made everything smaller?
Dan Caescu