Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

$2 or less Dust Boot - Fast and Cheap!

17 likes
28 opens
10 copies
2 comments
Daniel Brice

Project by

Daniel Brice

General Information

Fits the Dewalt DW611 router. After carving, a hole was drilled through the tabs, and a bolt and wingnut was inserted for tightening to the router. Used scrap stiff fabric and stapled it to the edges, and cut to make fringes.

Like this project Open in Easel®
Andrew Petzold
The link doesn't open the project
Andrew Petzold
Chris Reetz
same here - linkie no workie...
Chris Reetz