3 minutes
Clamp the material down being careful to avoid areas being cut.
20 minutes
Cut it out in Easel.
– The fixture will be held down typically by the slots on the outside
– The pocket is for starting the material release by inserting and lifting up with a screw driver
– The holes on the inside are optional and help for alignment and to be extra safe holding the fixture to the wasteboard
5 minutes
Debur the cuts in the HDPE
5 minutes
2 minutes
Using 100 grit sand paper, lightly rough up the carving area that was just faced-off to give the tape a good surface for adhesion.