Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

10 inch cherry clock

James Wegner

Project by

James Wegner
Duvall, WA

General Information

I designed this clock to be cut with a 1/16th inch endmill. Could be personalized with a name or logo.

PS – Bill of Materials does not have wood as a selection.

Like this project
Material Description Price
Cherry Wood

Cherry Wood

1

1. Mount maple

1 minute

Be sure to obey whether you use the clock middle, or the lower left corner for your X Y position.
I used the center.

Mark the exact corners because you will be turning the piece over to carve the back. Must be repositioned correctly.

2

2. Install a 1/16th endmill

1 minute

Tighten correctly.

3

3. Follow the Easel instructions and carve.

53 minutes

Install your dust shoe if you have one

4

4. Turn the piece over

1 minute

Make sure the piece is as close to the previous position as possible. I designed in 1/8 inch wiggle room.

5

5. Change to a .25 endmill

1 minute

Tighten correctly

6

6. Follow the Easel instructions and carve.

3 minutes

Then just sand and finish.

Roger
can you add the download files, this is a nice clock
Roger
James Nelson
File?
James Nelson
John Bjelko
can you add the file please
John Bjelko
Torben Rene Kristensen
nice job, but where do i find til file?
Torben Rene Kristensen
Eric ILETT
Yet another, where is the file?
Eric ILETT
Todd Eaton
Can you publish the file?
Todd Eaton
Bob Anderson
is the file available to buy?
Bob Anderson
gail
please send file. it is a nice clock and easy put what u like on face clock
gail
Antoinette
nice
Antoinette
Antoinette
Is the file available?
Antoinette